Powerpoints, appliance circuits and the switchboard schedule

Powerpoints

1. 1
   Place a Powerpoint from Powerpoints & switches.
2. 2
   Open its details (i) and pick the Powerpoint type: Double Powerpoint, Double Powerpoint + USB-A, Double Powerpoint + USB-A+C or Weatherproof Double Powerpoint.
3. 3
   Set the height — 200, 300 or 1100 — or type your own.
4. 4
   Add a Note (optional) for anything the sparky should know.

Appliances and dedicated circuits

The Appliances category has a Dedicated circuit, cooktop, oven, microwave oven, dishwasher, electric fireplace, fridge, wine fridge and bar fridge.

1. 1
   Place the appliance and open its details.
2. 2
   Under Dedicated circuit — phase, choose Single phase or 3 phase.
3. 3
   Pick the Cable size and type the Estimated cable length (m).
4. 4
   Under Add to switchboard, pick the board it runs from. robot adds it to that board’s schedule for you.

Fill out the switchboard

1. 1
   From Switchboard, place a Meter panel (main board) or a Sub-board.
2. 2
   Open its details and set the Board size, Supply and Size of mains (e.g. 16mm² consumer mains).
3. 3
   Under Switchboard schedule, tap + Add breaker or + Contactor for each circuit — CB 1, CB 2 and so on — with what each one feeds.
4. 4
   Tap a circuit’s chain button to link it to the points it feeds on the plan.
5. 5
   Select the board and tap Show circuits to see it all drawn on the plan.

Download the switchboard schedule

Tap Next steps → Download → Switchboard schedule. It’s an editable PDF, so you can retype circuits on site.

Heated floors

1. 1
   Measure one wall first (Tools → Measure) so robot knows the scale.
2. 2
   From Heated floors, place a Floor heating thermostat.
3. 3
   Tap the thermostat and choose Shade the area this thermostat controls.
4. 4
   Tap the corners of the heated area, then finish the area. robot works out the square metres.