How to upload a floor plan and add floors

Upload the plan

1. 1
   On an empty floor, tap Upload your floor plan.
2. 2
   Pick an image (PNG or JPG) or a PDF. A photo of a printed plan is fine.
3. 3
   robot trims the white margins off for you.

Pick the page from a PDF

1. 1
   robot shows Reading your PDF… while it opens the file.
2. 2
   Under Pick the page with the plan, tap the page you want. Each page is labelled Page 1, Page 2 and so on.
3. 3
   You’ll crop to just the plan next.

Crop and rotate

1. 1
   Drag the crop box so it covers just the plan — leave out the title block and notes.
2. 2
   Tap ⟳ Rotate if the plan is on its side.
3. 3
   Tap Crop & place →. Or tap Use as-is to keep the whole page.

Replace or remove the plan image

Once a plan is loaded, you’ll see Replace and Remove plan at the top right of the canvas. Replace swaps in a new drawing — handy when the builder sends a revision. Remove plan asks you to confirm first.

Add, rename and delete floors

New plans start with one tab called Ground floor. Each tab shows a dot when it has a plan image, and a count of the items on it.

1. 1
   Tap + Add floor to add a level. It’s called Floor 2, Floor 3 and so on.
2. 2
   Double-click a floor tab to rename it — e.g. First floor, Garage, Granny flat.
3. 3
   Upload that level’s plan on the new tab.
4. 4
   To remove the level you’re on, tap Delete floor and confirm. Every item on that floor goes with it.

No drawing? Sketch the walls

1. 1
   On an empty floor, tap ✏️ Draw a floor plan — or open Tools → Draw walls.
2. 2
   Drag to draw a wall. Walls snap straight.
3. 3
   Tap Done in the banner when you’re finished.

Measure a known wall

robot works out the plan’s scale from measurements you label. Open Tools → Measure, tap two points (the ends of a wall you know), then type the size — e.g. 3600mm — and tap Done.

You need at least one measurement before robot can work out square metres for heated floors.